MITS: World’s #1 Selling PCB Prortotyping System of All Time
The one and only machine in the world to fabricate lines and spaces under 100µm (FP-21T Series)
Terms to represent the degree of accuracy
The one and only machine in the world to fabricate lines and spaces under 100µm (FP-21T Series)
Since high-frequency characteristics is necessary for RF circuit boards, it is important to
mill sharp edged lines and spaces as below
However, the lines and spaces milled by average prototyping machine with 60 degrees
milling cutter (without run-out in consideration) will result to the picture below;
un-perpendicular cutting edge, which is inadequate for RF circuit boards.
Reason why FP-21 series are capable
1. | Holds necessary tools to fabricate | ||||||
|
|||||||
2. | Low runout of the spindle motor | ||||||
|
|||||||
3. | Capable of Stepping fabrication | ||||||
Read more |
Reason why competitor’s machines are incapable
1. | They don’t own adequate tool bit | |||
|
||||
2. | Runout of the spindle motor is not specified | |||
3. | Incapability of Stepping fabrication |
Introduction Example
FP-21T / FP-21THP
|
FP-21T Precision
|
More features of FP-21T series
FP-21T / FP-21THP Performs spacing of 0.1mm or more in milling
|
![]() |
>>Samples |
FP-21T Precision
An Extreme precision machine which performs 50µm spacing. Optimal for microwave designs.
- Non-contact spindle head installed.
- Process methods, absolute and incremental, are easily changeable manually.
- By using the optional vacuum table, it enables to process thin materials (50µm minimum).
- Telecentric lense installed camera 60x (optional).
- PCB surface detection jig(optional).
>>Samples