Can you make the through hole plating after drilling?
We supply many kinds of through hole formation system. (such as through hole pin, conductive paste)
We supply many kinds of through hole formation system. (such as through hole pin, conductive paste)
An optional aluminum engraving bit makes it possible to mill on aluminun.
Both routing and drilling are possible.
When using the FP-21T Precision and vacuum table, it is 0.05mm (50µm). Other models without using the vacuum table, it is 0.2mm.
Fixing by Scotch tape is sufficient. Additionally, we supply two kinds of vacuum table.
FR-4 board, Paper phenol, Teflon, Strontium titanate, alminium, and acril material
The milling speed or spindle rotation speeds can configure easily. Additionally, the rough indication is written in the users' manual.
FP-21T Precision is 0.05mm (50µm) Other models are 0.1mm
From 150mm x 150mm (FP-21T Precision) to 400mm x 365mm (Auto Lab W)
DXF file and Gerber file. (CR-5000, Altium Designer (Protel), PADS, OrCAD, WinPCB, Eagle, Microwave Office, AutoCAD, AutoDesk etc)